I have this sheeter, but no manual. They're really quite easy to maintain and clean. The settings will depend on what you want your finished product to be.

I only run my doughballs through once through both the top and bottom rollers. I have the top set to do about 75% of the flattening, then turn the dough 45 degrees after it gets through the top. Private Placement Pdf.

Items found similar to 'ACME MRS11 Dough Sheeter Manual And Parts List'. ACME MRS11 DOUGH ROLLER, BENCH PIZZA DOUGH. $2,710.00; Buy It Now; Acme Dough Roller Bench. Acme MRS11 Bench Dough Roller Specs Keywords: Acme, Bench Dough Roller, Acme MRS11, Acme Spec Sheet, MRS11 Spec Sheet Created Date: 6/19/2007 11:53:16 PM.

Then the bottom roller is set just a little thinner to make the dough round instead of oval. I have my top roller set at 1 and the bottom set at 2 ticks under 1. Sometimes the settings need to be tweaked a little bit depending on the dough. If you use enough flour for dusting, and you have stainless steel rollers, cleanup is a breeze. Just unplug it and wipe it down.

I only disassemble mine a couple times a year to oil the chains and give it a thorough cleaning, but there's never much on the inside. Pay close attention to how the blades come out (the plastic/nylon) scrapers on metal rods. There should be 4 (I think). Don't lose the springs. Actually, I suggest pinching them with pliers on one end so they can't come off the scraper. Dump the scrapers into the sink and wash (leave them on the rods).

Use a green scrubby to clean the rollers. Personally, I just jam the switch so it thinks the back is closed and turn it on and put the scrubbie on it. If the sheeter tries to take the scrubbie, let it. You will NOT win that fight. Rinse the rollers with a clean wet cloth. Dry the rollers. Now use a pastry brush with veggie oil and coat the rollers lightly.

Put the scrapers back in and you're done.

The 7447 does not have a release lever. To change the belt, you must release tension of the rollers by pushing the front roller straight back until you hear it click and lock in position to change paper. Remove old paper and replace with new paper.

Make sure if new paper has directional arrows to install properly. Now you must release the front roller to put tension on paper.

To do this push the front roller from the side that has the adjustment screw. This will release the front roller and allow it to go back into position.

Be careful as it pops back quickly and with some force. Turn on sander and adjust centering of paper with adjustment screw found near the front and side of sander. Jun 13, 2011 . To change the belt, you must release tension of the rollers by pushing the front roller straight back until you hear it click and lock in position to change paper.

Remove old paper and replace with new paper. Make sure if new paper has directional arrows to install properly. Now you must release the front roller to put tension on paper. To do this push the front roller from the side that has the adjustment screw.

This will release the front roller and allow it to go back into position. Be careful as it pops back quickly and with some force. Turn on sander and adjust centering of paper with adjustment screw found near the front and side of sander. Aug 27, 2010 .